![]() ![]() one click in bedroom turns on bedroom light, one click in living turns on livingroom light). ![]() This is to avoid reprogramming the wrong Beacon. Having a button with 1-2-3 click functionality can be used for various services.īeside with presence software, the same button same number of click can be used for different function (i.e. Step 1: Power down Unplug any Beacons that may be in range of your device used to reprogram. I think its pretty cool object for the home assistant community. I would love your feedback because I’m working on such a thing and want to make get feedback on what would make it a good product. Is that a fair trade-off for the added customizable button functionality or a deal-breaker and you absolutely need to be able to customize the ID, advertising rate, etc? I just don’t have the resources to make it work with the existing apps, nor to go and write my own for Android and iOS. It’ll also send out its battery life and which mode it’s in so you could see that on the Presence Server UI.īut, the trade-off is that it will come hardcoded with that Eddystone UID, beacon advertising rate, and power gain level. ![]() In just button mode, it’ll act the same was as described above as a button, but not advertise often as a beacon to save battery. It will use only moderate battery life, advertise every 400ms at 0 dBm, etc.Īnd when you push its button, it’ll send out an MQTT message to some button-topic saying it was pushed X times (so you could do single, double, triple clicks and different actions for each if you want). In beacon+button mode, it’ll behave like an Eddystone beacon with a guaranteed unique ID so you don’t need to worry about changing it to not overlap and some sensible defaults. Its LEDs would indicate which mode you’re in. You could switch modes but holding down the button for 2 seconds. What if I were to offer you a button that could switch modes, so it could be both a beacon and button at the same time, or save battery and be only in “butto-only mode”. Q: I dont know whats my beacon Identifier, how to get it A: You can use the Locate App (mentioned below) or the RadBeacon Config App If you have furt Seller. But I’m not sure I can replicate their exact behaviour in regards to the app. To make these act as a Happy Bubbles button, I basically need to rewrite their firmware, which is fine, I can do it. So that’s something I would like your opinion on, if you don’t mind. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |